Partner AVS programming codes

[Dave]

Anyone know the DTMF specs for various Partner phone system
functions? I'm trying to simulate the "Recall" feature (F03) using a
Dialogic D4/PCI card. Actually that's all I need. I need to send a
hookflash to the CO line from a PC based IVR system.

Actually I may be way off base here - I'm assuming the phones use DTMF
or some type of tones to tell the processor what to do when a feature
button on the hand set is pressed, but I don't actually have a partner
phone to test that theory.


Dave

[Dave]

Post by Dave
Anyone know the DTMF specs for various Partner phone system
functions? I'm trying to simulate the "Recall" feature (F03) using a
Dialogic D4/PCI card. Actually that's all I need. I need to send a
hookflash to the CO line from a PC based IVR system.
Actually I may be way off base here - I'm assuming the phones use DTMF
or some type of tones to tell the processor what to do when a feature
button on the hand set is pressed, but I don't actually have a partner
phone to test that theory.
Dave

...It's an *ACS*

[TouchToneTommy]

Post by Dave
Anyone know the DTMF specs for various Partner phone system
functions? I'm trying to simulate the "Recall" feature (F03) using a
Dialogic D4/PCI card. Actually that's all I need. I need to send a
hookflash to the CO line from a PC based IVR system.
Actually I may be way off base here - I'm assuming the phones use DTMF
or some type of tones to tell the processor what to do when a feature
button on the hand set is pressed, but I don't actually have a partner
phone to test that theory.
Dave

# on a single line phone is equivelant to Feature on a system phone.
But you will need to be on Intercom to do it. So, assuming that you
are on a CO line with an incoming call, and you need to flash the CO
line to initiate a CO transfer, you would flash, which puts your
caller on system hold, brings you to Intercom dial tone, dial #03 for
CO flash, pause, then dial the outgoing number, pause again, then
disconnect.

Good luck!!